Captures a frame using BitFlow frame grabber.
|inBoardNumber||Integer||Index of board|
|inInputQueueSize||Integer||1 - 200||Number of incoming frames that can be buffered before the application is able to process them|
|inTimeout||Integer||1 - 3600000||Capture timeout|
|inTriggerMode||BitFlowTriggerMode||Trigger mode of the current camera|
|inTriggerAssignments||BitFlowTrigAssignments||Assign trigger to acquisition engine|
|inTriggerAPolarity||BitFlowTrigPolarity||Polarity for trigger B|
|inTriggerBPolarity||BitFlowTrigPolarity||Polarity for trigger A|
|outFrameID||Long?||Captured frame ID|
Board driver software
This filter is intended to cooperate with board using its vendor SDK. To be able to connect with board it is required to install BitFlow SDK software. Currently Adaptive Vision Studio requires BitFlow SDK version 6.30.
BitFlow SDK can be downloaded from following website: http://www.bitflow.com (registration may be required).
Running applicationThis filter uses camera configuration files, which are loaded to register. To load this file to register you should use SysReg application from BitFlow SDK.
To identify the camera, configuration file should be loaded to Adaptive Vision Studio, using inCameraFileName input. Choosing index of board is too necessary.
Camera file must be located in configuration directory. Default configuration directory should be "C:\BitFlow SDK 5.90\Config". After that, correct directory should be used - it depends on type of board installed in system.
To change trigger options or digital outputs, use Adaptive Vision Studio(see "See also" paragraph). Another parameters might be changed by creating new configuration file. Configuration tool "CamEd" available with BitFlow SDK 5.90 should be used.
Supported pixel formats
This filter is available on Basic Complexity Level.
This filter is member of Bitflow_GrabImage filter group.