You are here: Start » Program Examples » Washers

Washers

Aim

This example shows how to find washers with defects or not properly centered.

Input

Set of images with multiple washers.

Output

Image with marked broken and not properly centered washers.

Histogram of distances between inner and outer contour of a washer.

Hints

Washers can be located by thresholding image and splitting resulting region into blobs.

Filter FitCircleToStripe can be used to find inner and outer circle of a washer.

Labeling connections is explained in this article.

Solution (AVS)

  1. Use EnumerateImages filter to load input images.

  2. Add ThresholdToRegion filter. Set inMinValue to Auto and inMaxValue to 200.0 to extract washers.

  3. Add SplitRegionIntoBlobs filter to obtain separate washers.

  4. Use RegionMassCenter filter to calculate washer centers. Click on the outMassCenter twice and change its name to MassCenters

  5. Add CreateCoordinateSystemFromPoint filter and connect MassCenter to inPoint.

  6. Add FitCircleToStripe filter. Connect Image to inImage. Connect outCoordinateSystem to inFittingFieldAlignment, that way you will only need to specify fitting field for one washer.

    • Run program to refresh the image and coordinate system, they will be later used to specify fitting field.

    • Specify inFittingField. In fitting field editor select washer with coordinate system inside:

    • Set inScanCount to 20 and inMaxIncompleteness to 0. This will make the filter detect only complete washers and skip broken ones.

    • Using Show/Hide Ports show outInnerCircle.Center and outOuterCircle.Center. Change their names to InnerCircleCenter and OuterCircleCenter

  7. Add PointToPointDistance filter to measure distance between the centers of inner and outer circle. Change the name of the output to the WasherErrorOrNil

  8. To create histogram of distances:

  9. Create a step macrofilter and name it DrawResults.

    • Connect Image to DrawResults to create a new macrofilter input. Check Array checkbox.

    • Connect MassCenters and WasherErrorOrNil to DrawResults in order to create new inputs. Check Array checkbox.

    • Double-click on DrawResults to edit the macrofilter.

    • Add a new formula to generate labels for washers. Create Real? input inDistance.

    • Create formula outputs:

      • outString, type String?:

        (inDistance == Nil) ? "Invalid" : ((inDistance < 0.5) ? "OK" : "NOK")

      • outIsWasherOk, type Bool?:

        outString == "OK"

    This will mark washer as valid when distance between centers is less than 0.5 and the washer is not broken.

Macrofilter Main

Macrofilter DrawResults draws inspection results on input image

Used Filters

Icon Name Description
DrawStrings_MultiColor Draws strings (text) on an image with multiple colors.
EnumerateImages Emulates image acquisition with images stored on disk.
ThresholdToRegion Extraction of a region of objects that can be defined by a salient brightness.
PointToPointDistance Measures the distance between two points.
CreateCoordinateSystemFromPoint Most often used to define an object alignment from results of 1D Edge Detection or Blob Analysis.
CreateHistogram Creates the histogram of the array of real numbers.
RegionMassCenter Computes a point with coordinates equal to the average coordinates of the region's pixels.
FitCircleToStripe Precise detection of ring-shaped objects, whose rough location is known beforehand.
SplitRegionIntoBlobs Segmentation of a region into individual objects when the objects do not touch each other.
RemoveNils This filter is useful e.g. when inspecting multiple objects while some of the inspections may fail (Nil result). RemoveNils is used to ignore the failed cases in the final result.

Further Readings