You are here: Start » Filter Reference » Camera Support » NET SynView » SynView_SetUserOutput
Basic| Module: | ThirdParty |
|---|
Sets SynView user outputs.
| Name | Type | Description | |
|---|---|---|---|
 |
inDeviceID | String* | Tries to find the camera in all available IDs (UserID, VendorName, ModelName...) |
|
inUserOutput | SynViewUserOutputs | User output for configuration |
|
inValue | Bool | Status of the selected user output |
Description
Digital IO output lines can be driven by toggling values of the corresponding user outputs - select the User Output Number, then set its bool value.
To connect a user output with a digital output use the SynView_ConfigureDigitalIO filter.
User outputs can be used to enable synView timers for advanced digital outputs control. To configure it use the SynView_ConfigureTimer filter, setting Timer Trigger Source accordingly.
More info about user outputs can be found in the SynView Manual: Section 6.7.5 "User output configuration."
Remarks
Camera driver software
This filter is intended to cooperate with cameras using their vendor's SDK. In order to connect with the camera, it is required to install SynView SDK software with camera dedicated drivers.
SynView SDK can be downloaded from the following website: https://net-gmbh.com/en/machine-vision/products/software
To verify the driver installation, you can run SynView Explorer (in the directory where camera drivers where installed). If the camera was detected and you can see the view from the camera, you can use SynView camera SDK in Aurora Vision Studio.
Recommended SynView SDK version for Aurora Vision Studio usage is 1.03.014.
Camera identification
When there is only one camera connected, the field inDeviceID can be set to Auto. In this situation, the first available camera will be used.
inDeviceID can be used to pick one of multiple cameras connected to the computer. DeviceID can be set to:
- UserID - User ID (also known as nickname) of the selected device,
- VendorName - Name of the manufacturer of the device,
- ModelName - Model name of the device,
- DisplayName - Device display name,
- IPAddress - Current IP address of the selected device (GigE Vision devices only),
- MACAddress - MAC address of the selected device (GigE Vision devices only),
- SerialNumber - String representation of camera's unique serial number.
Complexity Level
This filter is available on Basic Complexity Level.
Disabled in Lite Edition
See Also
- SynView_ConfigureDigitalIO – Configures SynView digital IO.
- SynView_ConfigureTimer – Configures one of the internal hardware timers available in the camera.
- SynView_GetDigitalIOStates – Gets SynView digital IO states.
- SynView_GrabImage – Captures a frame using SynView.
