Back to Adaptive Vision Studio website

You are here: Start » Filter Reference » NET ICube » ICube_SetParamAuto

ICube_SetParamAuto


Sets a parameter of type auto in an ICube device.

Name Type Description
inDeviceID Integer* Index of a camera
inType Integer Type of the parameter to set (see Parameter Definitions in the API Header)
inValue Bool 1 == set auto, 0 == unset auto.

Description

If auto mode is supported, this filter sets/unsets auto mode of the parameter specified by inType. It executes the ICubeSDK_SetParamAuto ICube SDK function.

Remarks

To be able to use an ICube camera, you need to install the camera driver. You can find it at the following address (select binaries):

https://net-usa-inc.com/en/usb2.0.html or https://net-usa-inc.com/en/usb3.0.html

Please make sure that the ICube SDK is installed properly on your computer. To verify the driver installation, you can run iControl.exe. If the camera was detected and you can see the image from it in this application, you can use your ICube camera in Adaptive Vision Studio.

Recommended ICube SDK version for Adaptive Vision Studio usage is v2.0.4.8.

The full description of the camera parameters can be found in the ICube SDK documentation.

Multithreaded environment

This function is not guaranteed to be thread-safe. When used in multithreaded environment, it has to be manually synchronized.

Complexity Level

This filter is available on Basic Complexity Level.

See Also