You are here: Start » Filter Reference » Hardware Support » Z4Sight » Z4Sight_RegisterEdge

Z4Sight_RegisterEdge

Module:	ThirdParty

Registers an edge in a command list.

Name	Type	Range	Description
inDeviceID	Z4SightSystemAndDeviceIdentifier *		Device identification.
inCommandList	Integer	1 - 2	I/O command list.
inCommandBit	Integer	0 - 7	Bit of the command list.
inEdgeType	Z4SightEdgeType		Type of the edge to register.
inReferenceMoment	Long *		Value of counter for which the command is to be registered (in seconds or counts).
inDelay	Real	0.0 -	Delay from the specified counter value.

Remarks

I/O device driver software

This filter is intended to cooperate with a Zebra 4Sight device using its vendor SDK. To be able to connect to the device, it is required to install Matrox MIL X SDK. Zebra 4Sight industrial PCs usually come with a preinstalled runtime license.

Add DLL path to system environment variable may be required.

Recommended Matrox MIL X SDK version for Aurora Vision Studio usage is V22H1 (10.60.0776).

Device identification

Device field can be used to specify the number (rank) of the target board of the specified system type. Device can be set to:

DEFAULT - Specifies the default board. The default board is set in the MILConfig utility.
DEVn - Specifies the device number (rank) of the board (where 0 <= n <=15).

System field can be used to specify the system type. System can be set to:

HOST - Specifies the default build-in system like IO in industrial PC.
CONCORD - Specifies the IO system from Concord framegrabber.

This filter allows to register an edge in one of the command lists. The specified command list must be configured using Z4Sight_ConfigureIOCommandList prior to using this filter.

Complexity Level

This filter is available on Advanced Complexity Level.

Disabled in Lite Edition